Mounting hardware will come shipped with every sign. Our standard hardware is a set of four 1" brass angles. Smaller signs can be wall-hung sufficiently using just two brackets as shown in the pictures below. The tabs of the brackets go behind the sign. (Go to our Hardware Page for more mounting options).
Step 1). Hold sign in position, with brackets in place, and mark outside edges of brackets with a pencil. (see pics).
Step 2). Screw all clips to siding. After the brackets are up, put the sign back in between the brackets and eyeball it for level. Get a friend to help if you're not sure, so they can adjust it while you stand back and confirm it looks right.
Step 4). While you've got the sign level in the brackets, install the screws into the edges of the sign as shown below. Pre drilling pilot holes for the screws isn't necessary, but something like an icepick could be used to punch some starter-holes. Either way, the brass screws that came with the brackets will go in easy enough with a hand screwdriver. Snug the screws down and you're all set.
We'll post more pictures in the future of post mounting and how to deal with brick and stucco walls. In the meantime if you have more questions or an unusual mounting need, please drop us an email or call toll free 800-509-SIGN (7446).
If you have any questions about the site or the products, please email us for a quick reply.
79 Freemans Way, Brewster, MA 02631
All information and graphics on this Web site are copyrighted 2002 by CarvedHomeSigns.com.